Sony DDU1632 Manual

The Sony DDU1632 is a high-performance internal DVD-ROM drive designed for desktop computers, featuring fast read speeds for DVD and CD media, ATAPI/IDE interface compatibility, and reliable data access. Below are key sections for installation, features, specifications, operation, and troubleshooting.

Features at a Glance

Key components: Internal DVD-ROM drive, IDE interface cable, mounting screws, audio cable, user manual.

Installation

Unpack and inspect contents. Ensure computer is powered off and unplugged.

1. Open computer case: Remove side panel to access drive bays.
2. Set jumper: Configure as Master or Slave per your IDE channel setup.
3. Mount drive: Secure in 5.25-inch bay using provided screws.
4. Connect cables: Attach 40-pin IDE cable, 4-pin power connector, and audio cable if needed.
5. Close case and power on.

WARNING! Handle drive carefully; avoid static discharge. Ensure all connections are secure.

First-Time Setup

After hardware installation, configure system software.

1. BIOS detection: Enter BIOS setup to ensure drive is recognized.
2. OS detection: Boot into operating system; drive should appear automatically.
3. Install drivers: Use included CD or download latest from Sony support site if required.
4. Test drive: Insert a disc to verify reading functionality.

CAUTION! Ensure proper ventilation around drive bay.

Specifications

• Model: DDU1632
• Interface: ATAPI/IDE (UDMA mode 2)
• Data Transfer Rate: DVD: 22.16 MB/s max; CD: 7.2 MB/s max
• Supported Media: DVD-ROM (single/dual layer), DVD-R, DVD-RW, CD-ROM Mode 1, CD-ROM XA, CD-DA, CD-R, CD-RW
• Dimensions: 146 mm (W) x 41.3 mm (H) x 170 mm (D)
• Weight: Approx. 0.9 kg
• Power Requirements: +5V DC ±5%, +12V DC ±10%
• Operating Temperature: 5°C to 45°C
• Operating Humidity: 10% to 80% RH (non-condensing)

Controls and Operation

Front Panel: Eject button, LED activity light, emergency eject hole.

Software Controls: Use OS or media player to play, pause, stop, eject.

Jumper Settings: MA (Master), SL (Slave), CS (Cable Select). Audio: Connect 4-pin cable to sound card for CD audio playback. LED: Solid when reading; blinking during access.

Connecting to System

IDE: 40-pin cable to motherboard IDE port. Power: 4-pin Molex connector. Audio: 4-pin cable to sound card (optional).

1. Power off computer and unplug.
2. Set jumper to Master (if single drive on cable) or Slave (if secondary).
3. Connect IDE cable (pin 1 to red stripe).
4. Connect power and audio cables.
5. Secure drive with screws.

Tip: Ensure IDE cable is not twisted or pinched.

Playing Media

Supports DVD-Video, DVD-ROM, audio CDs, CD-ROM.

1. Insert disc: Press eject button, place disc label-side up, close tray.
2. Access content: Use file explorer or media player software.
3. Eject: Press eject button or use software eject command.
4. Emergency eject: Use paperclip in small hole if power is off.

WARNING! Do not force tray; keep discs clean and free of scratches.

Maintenance

Keep drive clean and dust-free. Use compressed air to blow out dust from front.

CAUTION! Do not disassemble drive; no user-serviceable parts inside.

Regulatory Information

FCC Part 15: Class B digital device; complies with interference limits. CE marked. Copyright © Sony Corporation. For support, visit www.sony.com/support or contact Sony customer service.

Troubleshooting

Reset: Power cycle computer.

Service: Contact Sony support or authorized service center.